A local DATV signal from Portsdown (Ugly mode is fine) or any other DATV transmitter - a short piece of wire in the tuner input socket will probably pick up enough signal but be careful - there maybe DC volts on the socket.A satellite signal from your domestic satellite dish.If you have completed the installation and tested your system by running the test programs, you now need to arrange a test signal which can be one of the following: The Minitioune software is very comprehensive DVB-S receive and diagnostic software but can be a little overwhelming when you first run it! Running the test softwareĬonnect up your MiniTiouner to the PC USB port and apply volts - then run the test programs found in the directory where you extracted MiniTiouner to.Īll test should pass - if it fails the USRC filter test try running the install_usrc_ax_winXP.exe file in the directory and run the test again. The recommended cable is a Lindy Cromo Lindy cable USB 2.0 type A/mini-B 1m long.
It is absolutely essential you use a high quality USB cable or the program will frequently freeze and crash with no warning The MiniTiouner hardware is connected to the PC via USB2 mini cable.
MINITUNE TESTER FULL
Full installation procedure is at the bottom of this page. You will need Version v0.6 or newer if you have built a MiniTiouner Version 2 board with a Serit tuner (or a Serit tuner on a version 1 board with adapter card). You must do a small modification to the hardware to run Version 0.8 or later software before starting the program - see MiniTiouner_hardware_Version_2#MiniTiouner_version_0.8_software Previous versions
0 kommentar(er)
